Just talkin about games on WordPress.com

Posts tagged “4-player arcade control panel

I need more holes!

I’m a picky guy building the ultimate arcade machine so naturally I’m not completely satisfied with a pre-drilled control panel. I like most of it, or I wouldn’t have bought it. I just want to make a few minor adjustments.

I want to bring the center – top joystick hole down about 1 1/2 inches. I plan on installing an old-school Tron joystick and so there will need to be some room between the Tron stick and the protective glass in front of the monitor. I don’t want it too close to the trackball hole but I really want it further away from the glass where it will be easier to reach.

IMG_0639Originally the plans called for a 4-way joystick to be installed there for games like Pac-Man and Donkey Kong since an 8-way joystick just won’t work as well. But I am satisfied with my 8-way joysticks and how well they handle 4-way games. What I really want is a Tron stick. Since a Tron stick is much bigger in size it needs more room. Therefore I need to pull it away from the monitor but not so far as to block the trackball.

So I got a hole saw drill bit for my cheap cordless drill, carefully mapped out where I wanted it to go and drilled away.

IMG_0798IMG_0825IMG_0797

The first picture shows the new hole (towards the bottom of the picture with the 4 small indentations around it). To fill the old 4-way joystick hole, I glued and taped a wooden “plug” I had previously cut into the bottom of the old hole. Then I put in a healthy dose of spackling. And when it all dried, I removed the tape and carefully sanded the top.

I also had to increase the size of the spinner hole (the one with the brown square in the first picture) since the spinner I want fits the same size hole as a push button and not the smaller hole of an older spinner. In order to flawlessly drill a bigger hole over an already existing smaller hole I placed a circular piece of drilled out Lexan (coming up next) into the hole to act as a guide holding my drill with the hole saw bit dead center.

I was very satisfied with the results on both counts. I believed the artwork would cover the texture of the filled hole as if it never existed.